Honda ACCORD HYBRID 2005 Service Manual page 1509

7. Lift up the front seat, then detach the harness clips
(A) , and disconnect the seat belt switch connector
(B) on the passenger's manual seat, the power seat
harness connector (C) on the driver's 8-way power
seat, the seat heater connector (D) on the
passenger's manual seat, the side airbag connector
(E) on the driver's and passenger's seat, and the
OPDS unit connector (F) on the passenger's manual
seat.
Manual seat
B
8-way power seat
8. W i t h the help of an assistant, carefully remove the
front seat t h r o u g h the front door o p e n i n g .
9. Install the seat in the reverse order of removal, and
note these items:
• A p p l y liquid thread lock to the front seat
m o u n t i n g bolts before reinstallation.
• Make sure each connector is plugged in properly.
• Tighten the seat m o u n t i n g bolts to the specified
torque in the sequence s h o w n . Slide the seat all
the w a y back and tighten © and © , then slide it
f o r w a r d and tighten ® and © .
• Reconnect the negative cable to the battery.
• If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
Neutral) until the BAT displays at least three
segments.
• Enter the anti-theft codes for the radio and
navigation system, and then enter the customer's
audio presets.
• Set the clock.
Seat mounting bolts tightening sequence
Fastener Locations
10
x 1.25 m m
34 N-m (3.5 k g f m , 25 Ibf-ft)
20-81