Honda ACCORD HYBRID 2005 Service Manual page 1201

C a r r i e r B e a r i n g P r e l o a d I n s p e c t i o n
Special Tools Required
• Driver 07749-0010000
• Attachment, 83 m m 07HAD-SG00100
• Preload inspection tool 07YAJ-S3V0100
NOTE: If the transmission housing, torque converter
housing, differential carrier, tapered roller bearing,
bearing outer race, or thrust s h i m w e r e replaced, the
bearing preload must be adjusted.
1. Remove the bearing outer race (A), spacer (B), and
85 m m thrust shim (C) f r o m the transmission
housing (D) by heating the housing to about 212 °F
(100 °C) w i t h a heat gun (E). Do not heat the
housing more than 212 °F (100 °C).
NOTE: Let the transmission housing cool to r o o m
temperature before adjusting the bearing preload.
2. Replace the tapered roller bearing w h e n the outer
race is to be replaced.
3. Do not use a shim on the torque converter housing
side.
<2®
4. Install the 85 m m thrust s h i m (A) in the
transmission housing (B). If y o u replace the 85 m m
thrust s h i m w i t h a new one, use the same thickness
shim as the old one.
5. Install the spacer (C), and the bearing outer race (D)
in the transmission housing.
6. Drive the outer race securely in the housing w i t h
the special tools so there is no clearance between
the outer race, spacer, s h i m , and housing.
(cont'd)
14-365