Honda ACCORD HYBRID 2005 Service Manual page 1119

7. Pry the lock tab of the lock washer (J) on the control
lever (K), and remove the nut, lock washer, spring
washer and control lever.
8. Pry the lock tabs of the lock washer (L) on the
transmission range switch (M), hold the selector
control shaft (N) w i t h a 6.0 m m w r e n c h , and loosen
the locknut (O).
9. Remove the locknut and lock washer, then remove
the transmission range switch (two bolts).
10. Remove the input shaft (mainshaft) speed sensor
(P), output shaft (countershaft) speed sensor (Q),
and sensor washer (R).
11. Remove the ATF temperature sensor connector
f r o m the connector bracket (S) and harness clamp
f r o m c l a m p bracket, then remove the ATF
temperature sensor (T).
12. Remove the connector bracket (S) and 6.0 m m bolt
(U), then remove the line bolts (V), ATF cooler lines
(W), and sealing washers (X).
13. Remove the end cover (Y) (three bolts), snap ring
cap (Z) (two bolts), sealing plug (AA), and washer
(BB).
14. Remove the 3rd clutch transmission fluid pressure
switch (CO and sealing washer.
15. Remove the 4th clutch transmission fluid pressure
switch (DD) and sealing washer.
16. Remove the 2nd clutch transmission fluid pressure
switch (EE) and sealing washer.
17. Slip the special tool onto the mainshaft.
18. Cut the lock tab (A) of the mainshaft locknut (B)
using a chisel (C).
NOTE: Keep all of the chiseled particles out of the
transmission.
20. Pry the lock washer (C), and remove it.
(cont'd)
14-283