Honda ACCORD HYBRID 2005 Service Manual page 883

PCM CONNECTOR C (22P)
Terminal
Number
Wire Color
Signal Description Measuring Conditions/Terminal Voltage
C3 BLU/YEL
ATFT ATF temperature sensor signal input With ignition switch ON (II): 0.2—4.0 V
With ignition switch OFF: 0 V
C7
RED L S A A/T clutch pressure control solenoid
valve A control
With ignition switch ON (II): Pulsing signal
C8
GRN/WHT SH B Shift solenoid valve B control In the P, R, and N positions, 1st, 2nd, and 5th gears
in the D and D3 positions: Battery voltage
In 3rd and 4th gears in the D and D3 positions: 0 V
C9 BLU/WHT OP3SW 3rd clutch transmission fluid pressure
switch signal input
With ignition switch ON (II):
• Without 3rd clutch pressure: About 5 V
• With 3rd clutch pressure: About 0 V
CIO YEL/GRN A T P D Transmission range switch D position
signal input
In the D position: 0 V
In other than the D position: Battery voltage
C11 BLU/BLK OP2SW 2nd clutch transmission fluid pressure
switch signal input
With ignition switch ON (II):
• Without 2nd clutch pressure: About 5 V
• With 2nd clutch pressure: About 0 V
C12 GRN/YEL SG2 Sensor ground Less than 1.0 V at all times
C13 YEL/BLU
VCC2 Power supply circuit With ignition switch ON (II): About 5 V
C14 BLU ATP 2-1 Transmission range switch 2 and 1
position signals input
In the 2 and 1 positions: 0 V
In other than the 2 and 1 positions: Battery voltage
C15 BRN/WHT LS B A/T clutch pressure control solenoid
valve B control
With ignition switch ON (II): Pulsing signal
C16 GRN SHC Shift solenoid valve C control
In 1st, 3rd, and 5th gears in the D and D3 positions:
Battery voltage
In the P, R, and N positions, in 2nd and 4th gears in
the D and D3 positions: 0 V
C18 RED
ATP D3 Transmission range switch D3 position
signal input
In the D3 position: 0 V
In other than the D3 position: Battery voltage
C19 BLU/YEL
ATP FWD Transmission range switch D, D3 and 2
position signals input
In the D, D3, and 2 positions: 0 V
In other than the D, D3, and 2 positions: Battery
voltage
C20 BLU/YEL OP4SW 4th clutch transmission fluid pressure
switch signal input
With ignition switch ON (II):
• Without 4th clutch pressure: About 5 V
• With 4th clutch pressure: About 0 V
C21 RED/WHT ATP RVS Transmission range switch RVS (P, R,
and N positions) signal input
In the P, R, and N positions: 0 V
In other than the P, R, and N positions: Battery
voltage
C22 GRN/RED LSC A/T clutch pressure control solenoid
valve C control
With ignition switch ON (II): Pulsing signal
(cont'd)
14-47