Removing And Installing Front Silencer - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Removing
– Unfasten clamps -arrows-.
– Detach mounting -1- from the silencer.
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
– Remove silencer -2-.
Fitting
Install in the reverse order of removal, observing the following:
– Align exhaust system without tension
Specified torques
♦ ⇒ "1.1.5 Assembly overview - silencers, engine codes CJXA,
CJXE, CJXH, Leon SC, 5-door", page 396
1.4

Removing and installing front silencer

⇒ "1.4.1 Removing and installing rear front silencer, engine codes
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
CJSA, CJSB, CJXC, CJXH, CJXG", page 405
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
⇒ "1.4.2 Removing and installing front silencer, engine codes
CJSA, CJSB", page 406
⇒ "1.4.3 Removing and installing front silencer, engine codes
CJXA, CJXE", page 407
1.4.1 Removing and installing rear front si‐
lencer, engine codes CJSA, CJSB,
CJXC, CJXH, CJXG
Note
In the original factory equipment, this is a single piece with the
♦
centre silencer. Can be renewed individually for repair purpo‐
ses.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
Removing
– Remove the rear tunnel bridge -2-.
⇒ page 411
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
.
1. Exhaust pipes/silencers
405