Seat Ateca 2017 Workshop Manual page 298

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Removing
– Remove the ignition coil of cylinder "3"
– Release fasteners -arrows- and detach wiring duct -1- from
bracket.
– Clamp off coolant hoses -arrows- with hose clamps up to
25 mm - 3094- .
– Release hose clips and detach coolant hoses.
– Unscrew bolt -1- and remove coolant pipe (top).
Fitting
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Install in the reverse order of removal, observing the following:
respect to the correctness of information in this document. Copyright by SEAT S.A.
Note
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue (ET‐
KA) .
– Check coolant level
Specified torques
♦ ⇒ "3.1 Exploded view - coolant pipes", page 287
290
Rep. gr.19 - Cooling
⇒ page 452
⇒ page 244 .
.