Seat Ateca 2017 Workshop Manual page 427

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
❑ Removing and fitting
❑ Stress-free alignment of exhaust system
16 - Union nut
❑ Apply high-temperature paste to threads
❑ 45 Nm
17 - Temperature sender before particulate filter - G527-
❑ Apply high-temperature paste to threads
❑ Removing or installing
❑ 45 Nm
18 - Nut
❑ 9 Nm
19 - Support plate
❑ For pressure line
20 - Temperature sender after particulate filter - G506-
❑ Apply high-temperature paste to threads
❑ Removing or installing
❑ 45 Nm
21 - Bolt
❑ 9 Nm
22 - Bolt
❑ 9 Nm
23 - Screw-type clamp
❑ Renew after removal
❑ Installation position
❑ Specified torques and installation sequence
24 - Turbocharged
❑ Removing or installing
⇒ page 420
⇒ page 411
⇒ page 448
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 446
⇒ page 415 .
⇒ page 309
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
⇒ page 415 .
419
2. Emission control