Seat Ateca 2017 Workshop Manual page 271

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
• The frost protection must be effective down to at least -25 °C,
and approx. -36 °C in cold countries. The effectiveness of the
frost protection may only be increased if a higher level of frost
protection is required due to the climate. But only to -48 °C.
Otherwise, the cooling effect of the coolant will be impaired.
• When the engine is at operating temperature, the coolant level
must be at the »weld seam« -arrow-.
• When the engine is cold, the coolant level must be approx.
5 mm above the max. mark -arrow-.
Note
This excessive amount of coolant level is necessary since the
coolant level may decrease automatically due to bleeding proc‐
ess.
Extracting coolant:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
263
1. Cooling system/coolant