Seat Ateca 2017 Workshop Manual page 183

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Remove coolant pipe (top)
– Remove ignition coils
Vehicles with windscreen washer tank, right side:
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling tank for windscreen washer system .
For vehicles with particulate filter
– Disconnect electrical connector -arrow-from pressure differ‐
ential sender for particulate filter - G1037- .
Continued for all vehicles
– Disconnect connectors:
1 - For turbocharger air recirculation valve - N249-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
2 - For Hall sender 3 - G300- permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
3 - For the fuel metering valve - N290-
– Unplug electrical connectors -arrows- at actuators for cam‐
shaft adjustment.
– Remove bolt -5- and move earth wiring clear.
– Move electrical wiring harness clear at clip -4- and swivel it
forwards.
– Release fasteners -arrow-, detach wiring duct upwards from
bracket and press forwards.
CAUTION
Risk of damage to coolant pipes caused by deformation.
– Never attempt to reshape the coolant pipe.
– Remove bolts -1, 2, 3- and carefully swivel coolant line towards
rear slightly.
⇒ page 289 .
⇒ page 452 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
175
4. Valve gear