Seat Ateca 2017 Workshop Manual page 215

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Cut through seal between oil sump -4- and engine -1-.
– Use cutting tool - T10561- to do this.
Note
The sump is sealed with liquid sealant -2- ⇒ Electronic Parts
♦
Catalogue .
When hardened, the sealant has a high adhesive strength.
♦
– Separation is made centrally between bolts -3-.
– Position cutting tool - T10561- on seal -arrows- without it cant‐
ing.
– Drive in cutting tool - T10561- -3- using a hammer as far as it
will go -arrow-.
– Do not cant cutting tool - T10561- when doing this.
– Do not cutting tool - T10561- sideways.
– Do not lever with cutting tool - T10561- .
– Carry out the procedure at various points, until the oil sump
has been loosened.
– Use wedge - T10383/2- to further loosen detached positions.
– Using a plastic hammer carefully drive in wedge.
– Drive in wedge - T10383/2- only to same depth as sealing
surface.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Carefully release sump (bottom section) from bonded joint.
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Fit wedge - T10383/2- at another position and detach the bon‐
ded joint in the same way.
– Carefully detach lower part of sump from adhesive bond using
a commercially available scraper.
Fitting
CAUTION
Risk of eye injury caused by sealant residue.
– Wear safety goggles.
– Remove any remaining sealant on the sealing surfaces, using
a plastic rotary brush for example.
– Clean sealing surfaces; they must be oil and grease free.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
207
1. Sump, oil pump