Seat Ateca 2017 Workshop Manual page 426

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2.1.3 Assembly overview - Emission control, vehicles with particulate filter, all-
wheel drive
1 - Nut
❑ 9 Nm
2 - Bolt
❑ 9 Nm
3 - Nut
❑ 8 Nm
4 - Bolt
❑ 9 Nm
5 - Seal
❑ Renew after removing
6 - Bolt
❑ 20 Nm
7 - Holder for pressure differ‐
ential sender for particulate fil‐
ter - G1037-
❑ Assembly overview
⇒ page 420
❑ Removing or installing
⇒ page 442
8 - Bolt
❑ 8 Nm
9 - Catalytic converter
❑ With primary exhaust
pipe
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
❑ Protect catalytic con‐
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
verter from damage by
knocks and impact
❑ Removing and fitting
⇒ page 420
❑ Stress-free alignment of
exhaust system
⇒ page 411
10 - Bolt
❑ 20 Nm
11 - Support plate
❑ for the catalytic converter
12 - Nut
Specified torques and installation sequence
13 - Union nut
❑ Apply high-temperature paste to threads
❑ 45 Nm
14 - Bolt
❑ 20 Nm
15 - Particulate filter
❑ With front exhaust pipe
❑ Protect catalytic converter from damage by knocks and impact
418
Rep. gr.26 - Exhaust system
⇒ page 415 .