Removing And Installing High-Pressure Pipe - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Counterhold on hexagon -A-, and tighten union nut -arrow-.
– Wait at least 1 minute and check tightening torque.
– Connect fuel hoses -2- and -3-, and secure them with spring-
type clips.
– Connect connector -1- on fuel metering valve - N290- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Further assembly is basically a reverse of the dismantling se‐
respect to the correctness of information in this document. Copyright by SEAT S.A.
quence.
Note
Upon completion of any repair work, start the engine and check
the fuel system for leaks.
Specified torques
♦ ⇒ "7.1 Exploded view - high-pressure pump", page 380
7.3 Removing and installing high-pressure
pipe
Special tools and workshop equipment required
♦ Socket, SW 17 - T10456-
♦ Open end spanner insert, AF 17 - V.A.G 1331/6-
384
Rep. gr.24 - Mixture preparation - injection