Seat Ateca 2017 Workshop Manual page 32

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew bolt -1- and remove wiring of pressure differential
sender for particulate filter - G1037- -2- in
-direction of arrow-.
Note
Disregard -item 3-.
– Unscrew the four plastic nuts -arrows- on the left underbody
trim -1- and move the trim slightly downward.
– Disconnect and remove the electrical connectors -1-, -2- of the
temperature sensor in front of -G506- and behind -G527- par‐
ticulate filter.
– Prise out the securing clip -arrow- (for heat shield of the centre
tunnel) using the removal lever - 80 200- .
– Unclip the wiring of the sensors -G506- and -G527- from the
fasteners.
Vehicles with particulate filter, all-wheel drive
– Open spring-type clip -1- and remove the hose from pressure
differential sender for particulate filter - G1037- .
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Disregard -item 2-.
respect to the correctness of information in this document. Copyright by SEAT S.A.
24
Rep. gr.10 - Removing and installing engine