Seat Ateca 2017 Workshop Manual page 404

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
❑ Tighten bolted connections evenly
9 - Bracket
1.1.5 Assembly overview - silencers, engine
codes CJXA, CJXE, CJXH, Leon SC, 5-
door
Original equipment as single assembly together with rear silenc‐
er; to be renewed individually in event of repair
1 - Front silencer
❑ Combined in one unit
with rear silencer as
original equipment. Can
be renewed individually
for repair purposes.
❑ Removing and fitting
⇒ page 407
❑ Separating point
⇒ page 408
❑ Stress-free alignment of
exhaust system
⇒ page 411
2 - Bolt
❑ 20 Nm
3 - Support plate
4 - Retaining rings
❑ Renew if damaged.
5 - Rear silencer
❑ In the original factory
equipment, this is a sin‐
gle piece with the centre
silencer. Can be re‐
newed individually for
repair purposes.
❑ Removing and fitting
⇒ page 402
❑ With exhaust flap con‐
trol unit - J883-
❑ Separating point
⇒ page 408
❑ Stress-free alignment of
exhaust system
⇒ page 411
6 - Nut
❑ 30 Nm
7 - Clamps (rear)
❑ Before tightening, align exhaust system so it is free of stress
❑ Installation position
❑ Tighten bolted connections evenly
8 - Exhaust flap control unit - J883-
❑ Tightening torque
396
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 397 .
⇒ page 397
⇒ page 411