Removing And Installing Catalytic Converter - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2.1.4 Assembly overview - bracket and pipes for pressure differential sender for
particulate filter - G1037-
1 - Shield
2 - Nut
❑ 8 Nm
3 - Elbow stud
4 - Pressure differential sender
for particulate filter - G1037-
❑ Securing bolt, 8 Nm
❑ Removing or installing
⇒ page 375
5 - Bracket
6 - Bolt
❑ 9 Nm
7 - Shield
8 - Nut
❑ 8 Nm
9 - Bolt
❑ 9 Nm
10 - Bolt
❑ 9 Nm
11 - Bolt
❑ 9 Nm
12 - Bolt
❑ 20 Nm
13 - Pressure line
14 - Bolt
❑ 20 Nm
15 - Exhaust turbocharger
2.2 Removing and installing catalytic con‐
verter
⇒ "2.2.1 Removing and installing catalytic converter, vehicles
without particulate filter", page 420
⇒ "2.2.2 Removing and installing catalytic converter, vehicles with
particulate filter and front-wheel drive", page 427
⇒ "2.2.3 Removing and installing catalytic converter, vehicles with
particulate filter and all-wheel drive", page 433
2.2.1 Removing and installing catalytic con‐
verter, vehicles without particulate filter
Special tools and workshop equipment required
420
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.