Checking Fuel Pressure Sender G247 - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Pull off connector -arrow- from alternator, otherwise the bit can
be caught on the connector!
– Unscrew fuel pressure sender - G247- using bit, 27mm -
T40218- .
Fitting
Install in reverse order of removal, observing the following:
Specified torques
♦ ⇒ "2.1.1 Assembly overview - fuel rail with injectors, direct in‐
jection", page 343
5.3 Checking fuel pressure sender - G247-
Special tools and workshop equipment required
♦ Pressure sensor tester - VAS 6394-
♦ Adapters - VAS 6394/2-
♦ Adapter for the testing functions - VAS 5570-
♦ Torque wrench - V.A.G 1331-
♦ Vehicle diagnostic and service information system
Operation process
– Remove engine cover panel
CAUTION
The fuel system is pressurised.
Risk of injury due to fuel which may spurt out.
– Wear safety goggles.
– Wear protection gloves.
– Release pressure: place clean cloth around connection and
carefully open connection.
– Remove fuel pressure sender - G247-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Instead of fuel pressure sender - G247- , screw in adapter -
respect to the correctness of information in this document. Copyright by SEAT S.A.
VAS 6394/2- and tighten to torque specified for fuel pressure
sender - G247- .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 57 .
⇒ page 369 .
EA 888 III. Gen) - Edition 10.2018
371
5. Sensors