Seat Ateca 2017 Workshop Manual page 172

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Remove guide rail -1-. To do this, use a screwdriver to release
catch -arrow-, and press off guide rail forwards.
– Press retainer for oil pump chain tensioner in
-direction of arrow- and lock in place using dowel pin -
T40011- .
– Unscrew bolt -1-, and remove chain tensioner.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Unscrew bolts -1-, and remove guide rail -2-.
– Remove camshaft timing chain from camshaft sprockets, and
guide it downwards.
– Fit turning over tool - T10531/3- . At "TDC position" the flat
section -1- faces upwards. Screw on flange nut - T10531/4- .
Turn crankshaft with a 32 mm open-end spanner anti-clock‐
wise to move it out of "TDC position".
164
Rep. gr.15 - Cylinder head, valve gear
respect to the correctness of information in this document. Copyright by SEAT S.A.