Seat Ateca 2017 Workshop Manual page 209

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
1 - Nut
❑ 9 Nm
2 - Oil level/oil temperature
sensor - G266-
❑ Removing and fitting
⇒ page 215
3 - O ring
❑ Lubricate lightly with en‐
gine oil
❑ Must be renewed if re‐
moved
4 - Oil drain plug/sealing plug
❑ Sheet-metal sump: 30
Nm
❑ Turn the plastic sump
using the assembly tool
- T10549- until the end
5 - Seal / O-ring
❑ Renew seal after each
removal.
❑ Renew O-ring in case of
leaks.
6 - Gasket/sealant
❑ ⇒ Electronic parts cata‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
logue (ETKA)
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
7 - Bolt
❑ For baffle plate and oil
suction pipe
❑ Renew after removing
❑ 4 Nm + turn +45° further
8 - Anti-surge valve
❑ Renew after removing
9 - O-ring
❑ Renew after removing
❑ Lubricate lightly with engine oil
10 - Oil suction pipe
❑ Clean strainer if soiled.
11 - Centring sleeve
12 - Bolt
❑ Renew after removing
❑ Tightening sequence
13 - Oil sump - upper part
❑ Removing and fitting
❑ Oil sump upper part with 18 bolts – tightening sequence
❑ Oil sump upper part with 14 bolts - tightening sequence
❑ If the top section of sump is renewed, the baffle plate must be renewed as well.
14 - Cylinder block
15 - Drive chain for oil pump
❑ Mark direction of rotation before removing
⇒ Item 13 (page 201)
⇒ page 208
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
⇒ page 203
201
1. Sump, oil pump