Removing And Installing Piston Cooling Jet Control Valve N522 - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Installation position stage 3 oil pressure switch - F447-
4.3 Removing and installing piston cooling
jet control valve - N522-
Removing
Vehicles with windscreen washer tank, right side:
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling tank for windscreen washer system .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Continued for all vehicles
Note
Place a cloth underneath bracket for ancillaries to catch any es‐
caping engine oil.
– Unscrew bolt -1- and remove piston cooling jet control valve -
N522- -2-.
Fitting
Install in the reverse order of removal, observing the following:
Note
Replace the O-rings.
♦
Insert piston cooling jet control valves - N522- immediately in
♦
hole to avoid loss of oil.
– check oil level⇒ Maintenance ; Booklet 501 .
Specified torques
♦ ⇒ "4.2 Exploded view - oil pressure switches/oil pressure con‐
trol", page 222
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
4. Oil filter/oil pressure switches
223