Seat Ateca 2017 Workshop Manual page 169

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Vehicles with windscreen washer tank, right side:
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling tank for windscreen washer system .
Continued for all vehicles
– Disconnect connectors:
1 - For turbocharger air recirculation valve - N249-
2 - For Hall sender 3 - G300-
3 - For the fuel metering valve - N290-
– Unplug electrical connectors -arrows- at actuators for cam‐
shaft adjustment.
– Remove bolt -5- and move earth wiring clear.
– Move electrical wiring harness clear at clip -4- and swivel it
forwards.
– Release fastener -arrow-, detach wiring duct upwards from
bracket and press forwards.
CAUTION
Risk of damage to coolant pipes caused by deformation.
– Never attempt to reshape the coolant pipe.
– Unscrew bolts -1, 2 and 3-, and carefully swivel coolant line
towards rear slightly.
– Unplug electrical connector -1- at activated charcoal filter sys‐
tem solenoid valve 1 - N80- .
– Press release tabs on crankcase breather hose -2- and detach
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
hose.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove bolts -arrows- and remove the crankcase breather
system.
– Remove high-pressure pump
– Remove vacuum pump
– Remove engine bracket
– Remove front part of right wheel housing liner ⇒ General body
repairs, exterior; Rep. gr. 66 ; Wheel housing liners; Removing
and installing front wheel housing liner .
– Remove engine support
– Remove the upper cover of the distribution chain
⇒ page 121 .
⇒ page 381 .
⇒ page 115 .
⇒ page 45 .
⇒ page 69 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
161
4. Valve gear