Removing And Installing Centre Silencer - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1.2.5 Removing and installing rear silencer,
Ateca Cupra
Special tools and workshop equipment required
♦ Engine and gearbox jack - VAS 6931-
Removing
– Loosen clamp -arrow- and push towards rear.
– Unplug electrical connectors at control units -3- of exhaust
flaps ⇒ page 400 .
– Disengage rear silencer -2- from the hanger -4-.
– Position engine and gearbox jack under silencer and prop it
up.
– Unscrew bolts -1-.
– Remove rear silencer -2-.
Installation
Install in the reverse order of removal, observing the following:
– Align exhaust system without tension
Specified torques
♦ ⇒ "1.1 Exploded view - silencers", page 391
1.3

Removing and installing centre silencer

Note
In the original factory equipment, this is a single piece with the
♦
centre silencer. Can be renewed individually for repair purpo‐
ses.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
404
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 411 .