Seat Ateca 2017 Workshop Manual page 402

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Installation position of rear clamp
– Fit clamp in position shown.
• Bolt connections face to left
• Bolt -arrow- must not protrude beyond lower edge of clamp.
1.1.3 Assembly overview - silencer, engine
codes CJSA, CJSB, CJXC, Leon ST
Original equipment as single assembly together with rear silenc‐
er; to be renewed individually in event of repair
1 - Middle silencer
❑ Disconnecting exhaust
pipes/silencers
⇒ page 408
❑ Stress-free alignment of
exhaust system
⇒ page 411
2 - Retaining rings
❑ Renew if damaged
3 - Support
4 - Bolt
❑ 20 Nm
5 - Tension sleeve
❑ Installation position
⇒ page 397 .
❑ Stress-free alignment of
exhaust system
⇒ page 411
❑ Tighten bolted connec‐
tions evenly
❑ 30 Nm
6 - Rear silencer (right-side)
❑ Original equipment as
single assembly togeth‐
er with rear silencer; to
be renewed individually
in event of repair
❑ Disconnecting exhaust
pipes/silencers
⇒ page 408
❑ Stress-free alignment of
exhaust system
⇒ page 411
7 - Support plate
8 - Retaining rings
❑ Renew if damaged
394
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.