Removing And Installing Ancillary Bracket - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew knurled screws -arrows-, and remove support -
T10531/1- .
– Tighten vibration damper bolt using counter-hold tool -
T10355- .
– Screw in new securing bolts -arrows-.
Continue installation following reverse order for removing.
Specified torques
♦ ⇒ "1.1 Exploded view - cylinder block (pulley end)", page 58
1.5 Removing and installing ancillary brack‐
et
Special tools and workshop equipment required
♦ Drip tray for workshop hoist - VAS 6208-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Removing
– Drain coolant ⇒ page 239
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
.
EA 888 III. Gen) - Edition 10.2018
1. Cylinder block (pulley end)
67