Seat Ateca 2017 Workshop Manual page 405

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
9 - Middle silencer
❑ Combined in one unit with rear silencer as original equipment. Can be renewed individually for repair
purposes.
❑ Removing and fitting
❑ Separating point
❑ Stress-free alignment of exhaust system
Installation position of rear clamp
– Fit clamp in position shown.
• Bolt connections face to left
• Bolt -arrow- must not protrude beyond lower edge of clamp.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Exhaust flap control unit - J883- - tightening torque
Note
Renew nuts.
– Tighten bolts -4- to 3 Nm.
1.1.6 Assembly overview - silencer, engine
codes CJXA, CJXE, CJXH, Leon ST
Original equipment as single assembly together with rear silenc‐
er; to be renewed individually in event of repair
⇒ page 404
⇒ page 408
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
⇒ page 411
1. Exhaust pipes/silencers
397