Seat Ateca 2017 Workshop Manual page 455

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
♦ Tool set - T10395 A-
Removing
• Observe safety precautions when working on the exhaust sys‐
tem ⇒ page 3 .
– Remove rear centre underbody trim, if any, behind subframe
⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody
trim; assembly overview - underbody trim .
– Unscrew the four plastic nuts -arrows- on the left underbody
trim -1- and move the trim slightly downward.
– Release from bracket and disconnect electrical connector -2-
from temperature sender in front of particulate filter - G506- .
– Prise out the securing clip -arrow- (for heat shield of the centre
tunnel) using the removal lever - 80 200- .
– Unclip wires of the temperature sender in front of particulate
filter - G506- from fasteners.
Vehicles with all-wheel drive
– Unclip and disconnect wires -1- of particulate filter -2-.
Note
Disregard -item 3- and -arrows-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
3. Exhaust gas temperature regulation
447