Seat Ateca 2017 Workshop Manual page 283

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unplug electrical connector -1- on stage 3 oil pressure switch
- F447- -item 2-.
– Remove bolts -arrows- and detach toothed belt cover.
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
The drive sprocket bolt has a left-hand thread.
– Use torque wrench - V.A.G 1410- and insert tool - T10360- to
loosen bolt on coolant pump drive sprocket -1- and unscrew
three turns (counterhold at vibration damper).
Note
If for vehicles with manual gearboxes, the tool cannot be placed
on due to a fastening screw of the starter, unscrew screw approx.
15 mm.
– Remove toothed belt -2-.
Fitting
Installation is carried out in the reverse order; note the following:
Note
Replace the drive sprocket bolt.
♦
Note installation position of toothed belt sprocket
♦
⇒ Item 12 (page 269)
– Replenish coolant ⇒ page 240
Specified torques
♦ ⇒ "2.1 Exploded view - coolant pump and thermostat",
page 268
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
2. Coolant pump/thermostat assembly
275