Seat Ateca 2017 Workshop Manual page 445

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unclip wiring -1- and unscrew nuts -arrows-.
– Unscrew bolts -3-.
– Unscrew the bolts -arrows- and remove the heat protection
plate -1-.
– Mark the position of the propshaft to the flange of the bevel
box.
– To loosen and tighten propshaft, counterhold on rear final
drive.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
2. Emission control
437