Seat Ateca 2017 Workshop Manual page 133

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Cover with 15 bolts
– Unscrew bolts -1...15-.
– Prise off timing chain cover (bottom).
Fitting
Note
Note the expiry date of the silicone sealant.
♦
Silicone sealant ⇒ Electronic Parts Catalogue (ETKA) .
♦
The cover must be installed within 5 minutes after applying the
♦
silicone sealant.
Renew the bolts tightened with specified tightening angle.
♦
Renew seal and O-ring.
♦
Protect lubrication system against contamination. Cover open
♦
parts of engine.
– Eliminate the remains of sealant paste from the cylinder head
with a flat rasp.
– Clean surfaces; they must be free of oil and grease.
– Check that both dowel pins are fitted in cover -arrows-.
– Cut off nozzle of tube at front marking (nozzle dia. approx. 3
mm).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
125
2. Timing chain cover