Seat Ateca 2017 Workshop Manual page 352

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
10 - Connection
❑ For high-pressure line on fuel rail
❑ Renew after removing
❑ Lubricate threads lightly with clean engine oil
❑ Counterhold on fuel rail when tightening
❑ 40 Nm
11 - Bolt
❑ 5 Nm
12 - High-pressure pipe
❑ Moisten ball with clean engine oil
❑ Union nut 27 Nm, wait for 1 minute and retighten to 27 Nm
2.1.2 Assembly overview - fuel rail with injectors, indirect injection
1 - Retaining clip
❑ For fuel pressure send‐
er for low pressure -
G410-
2 - O-ring
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
❑ Renew after removing
3 - Adapters
❑ must be screwed tight
with the fuel sender for
low pressure - G410-
-pos. 4-
❑ 15 Nm
4 - Fuel pressure sender for
low pressure - G410-
❑ must with screwed tight
with the adapter
-pos. 3-
❑ Removing and fitting
⇒ page 373
❑ 15 Nm
5 - Fuel rail for injectors (intake
manifold)
6 - Bolt
❑ Qty. 2
❑ 9 Nm
7 - Fuel supply line
❑ To fuel rail for injectors
(intake manifold)
❑ Do not fit under stress
8 - Retaining clip
9 - O-ring
❑ Renew after removal
10 - Injector
❑ Ensure correct installation position
❑ Removing and fitting
344
Rep. gr.24 - Mixture preparation - injection
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 349