Seat Ateca 2017 Workshop Manual page 439

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew temperature sender before particulate filter - G527-
-1- from the particulate filter -4-.
– Unscrew bolt -1- and remove wiring of pressure differential
sender for particulate filter - G1037- -2- in
-direction of arrow-.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Note
Disregard -item 3-.
– Unscrew bolts -arrows-.
– Loosen clamp -1- between catalytic converter and front si‐
lencer, and push it in direction of travel -arrow-.
– Unscrew the nuts at the rear of the tunnel bridge and remove
the tunnel bridge ⇒ Body Repairs; Rep. gr. 66 ; Underbody
panelling; remove and install the front tunnel bridge .
RHD vehicles
– Unscrew bolts and remove steering rack heat shield ⇒ running
gear, axles, steering; Rep. gr. 48 ; steering rack, assembly
overview - steering rack .
Continued for all vehicles
CAUTION
Danger of accident from weight of catalytic converter.
– Seek help from a second a mechanic for the following work.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
431
2. Emission control