Seat Ateca 2017 Workshop Manual page 374

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Release hose clip -2- and detach air hose from charge air
cooler.
Note
Item -1- can be disregarded.
– Free coolant hose -3-.
– Unplug electrical connector -1- at charge pressure sender -
G31- .
– Remove bolts -arrows-.
– Release hose clip -2- on air hose and pull air hose off throttle
valve module - GX3- .
– Remove the air hose by lowering it.
– Unplug electrical connector -1- from throttle valve module -
GX3- .
– Unscrew bolts -arrows- on throttle valve module - GX3- from
underneath and remove throttle valve module - GX3- .
Fitting
– Install in reverse order:
– Clean the sealing surfaces of the sealing ring.
– Renew seal ring.
Specified torques
♦ ⇒ "4.1 Exploded view - intake manifold", page 358
– After throttle valve module - GX3- has been renewed, it must
be re-adapted to engine control unit - J623- . Use ⇒ Vehicle
diagnostic tester.
366
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.