Seat Ateca 2017 Workshop Manual page 50

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Initially screw in bolts -arrows- for gearbox mounting by hand
until they make contact.
– Adjust assembly mountings and tighten bolts
– Remove engine bracket - T10359- from engine.
– Install drive shafts ⇒ Running gear, axles, steering; Rep. gr.
40 ; Drive shaft; Assembly overview - drive shaft .
Vehicles with all-wheel drive
– Tighten propshaft on bevel box ⇒ rear final drive; Rep. gr.
39 ; Propshaft; ssembly overview - propshaft .
Vehicles with manual gearbox
– Install clutch slave cylinder ⇒ Rep. gr. 30 ; Clutch mechanism;
Removing and installing clutch slave cylinder .
– Installing control cables with counter-hold tool ⇒ Rep. gr. 34 ;
Selector mechanism; Control cables: assembly overview .
Vehicles with dual clutch gearbox
– Install and adjust selector lever cable ⇒ 7-speed dual clutch
gearbox 0CW; Rep. gr. 34 ; Selector mechanism; Exploded
view - Selector mechanism .
– Adjust selector lever cable ⇒ 7-speed dual clutch gearbox
0CW; Rep. gr. 34 ; Selector mechanism; Check and adjust
selector lever cable .
– Install selector lever cable ⇒ 6-speed dual clutch gearbox
0D9; Rep. gr. 34 ; Selector mechanism; Exploded view - Se‐
lector mechanism .
– Adjust selector lever cable ⇒ 6-speed dual clutch gearbox
0D9; Rep. gr. 34 ; Selector mechanism; Check and adjust
selector lever cable .
Continued for all vehicles
– Front exhaust pipe with catalytic converter: Assembly over‐
view ⇒ page 414 .
– Install air conditioner compressor ⇒ Rep. gr. 87 ; Air condi‐
tioner compressor; Drive unit for air conditioner compressor:
Assembly overview .
– Fit poly V-belt ⇒ page 60
– Install battery tray ⇒ Electrical system; Rep. gr. 27 ; Battery;
Battery: assembly overview .
– Electrical connections and routing ⇒ Electrical system; Rep.
gr. 97 ; Relay carriers, fuse carriers, electronics boxes; Over‐
view of fitting locations - relay carriers, fuse carriers, electron‐
ics boxes and ⇒ Current flow diagrams, Electrical fault finding
and Fitting locations.
– Install the air cleaner housing
– check oil level⇒ Maintenance ; Booklet 501 .
– Connect coolant hoses with plug-in connector on the heat ex‐
changer for heater ⇒ page 292
– Install subframe ⇒ Running gear, axles, steering; Rep. gr.
40 ; Subframe; Removing and installing subframe without
steering rack .
– Install front wheel housing liners ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Wheel housing liner; Removing and
installing front wheel housing liner .
– Check oil level.
42
Rep. gr.10 - Removing and installing engine
⇒ page 55
.
⇒ page 356 .
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.