Seat Ateca 2017 Workshop Manual page 130

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Insertable tool with e/c 10 opening - V.A.G 1783/1-
Removing
• Engine cold.
– Open filler cap -arrow- of the coolant expansion tank briefly to
relieve residual pressure in cooling system.
– Remove engine cover panel
Vehicles with windscreen washer tank, right side
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling tank for windscreen washer system .
Continued for all vehicles
– Release hose clip -1-, disconnect coolant hose and push to‐
wards right.
– Disconnect hose -2- for activated charcoal filter (press release
tab on hose) and move hose clear.
– Remove inlet camshaft control valve 1 - N205- / exhaust cam‐
shaft control valve 1 - N318-
– Unscrew bolt -1-, and unclip wiring harness -2-.
– Unclip guide tube from timing chain cover (top) in direction of
-arrow-.
– Slightly pull dipstick guide tube out of lower cover.
– Unclip wiring harness for camshaft control valves, and lay it to
one side.
122
Rep. gr.15 - Cylinder head, valve gear
⇒ page 57 .
⇒ page 186 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.