Install Ball For Forked Sleeve - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Checking valve timing - without markings on cylinder head
– Check valve timing; markings on camshaft timing chain and
cylinder head -arrows- must align with markings on chain
sprockets.
– The markings on the camshaft timing chain and the guide rails
for the chain -2- must oppose each other.
– The notch on the vibration damper must oppose the marking
on the lower cover of chain -3-.
Note
If the markings are not visible, check valve timing
– Attach bearing saddle and screw in bolts -arrows- hand-tight.
– Remove the Pinning tool - T40267- .
– Tighten bolts -arrows- for bearing saddle
– Install timing valves
– Install timing chain cover (top)
– Install vacuum pump
– Install high-pressure pump
– Install windscreen washer tank ⇒ Electrical system; Rep. gr.
92 ; Windscreen washer system; Overview - windscreen
washer system .
– After working on the chain drive, adapt learnt values in engine
control unit. To do this, switch on ignition and select the fol‐
lowing menu item in the vehicle diagnostic and service infor‐
mation system :
♦
0001 - Adaption diagnosis chain length
Further assembly is basically the reverse of the dismantling se‐
quence.
Specified torques
♦ ⇒ "4.1 Assembly overview - valve gear", page 153
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
♦ ⇒ "7.1 Exploded view - high-pressure pump", page 380
4.3

Install ball for forked sleeve

Special tools and workshop equipment required
⇒ page 128
⇒ Item 7 (page 129) .
⇒ page 121 .
⇒ page 115 .
⇒ page 381 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
⇒ page 148 .
.
185
4. Valve gear