Seat Ateca 2017 Workshop Manual page 49

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Vehicles with all-wheel drive
– Secure gearbox to engine.
– Screw in bolts -1- and -2- securing the holder of the bevel box
by hand.
– Note tightening sequence:
1 - Tighten screws -2-: 40 Nm.
2 - Tighten nuts -1-: 40 Nm.
Continued for all vehicles
– Install starter ⇒ Electrical system; Rep. gr. 27 ; Starter; Re‐
moving and installing starter .
– Guide engine/gearbox assembly into body.
– Initially screw in bolts -arrows- for engine mounting by hand
until they make contact.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine
41