Seat Ateca 2017 Workshop Manual page 20

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
♦ Securing element from gearbox support - 3282-
♦ Pressing-off lever - 80 - 200-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Protective glasses
♦ Protective gloves
♦ Double ladder
Removing
Note
The engine is removed downwards with gearbox. To do this,
♦
the subframe needs to be removed.
After removing of coolant or fuel lines, these must be sealed
♦
using the engine sealing cap set - VAS 6122- to prevent dirt
from entering or coolant or fuel from running out.
Fit cable ties in the original positions when installing.
♦
All cable ties which are opened or cut through when engine is
♦
removed must be replaced in the same position when engine
is installed.
CAUTION
On a warm motor, the cooling system is under high pressure.
Hot steam/hot coolant can escape - risk of scalding.
Risk of scalding to skin and body parts.
– Wear protection gloves.
– Wear safety goggles.
– Reduce excess pressure by covering cap of coolant expan‐
sion tank with cloths and opening it carefully.
12
Rep. gr.10 - Removing and installing engine