Removing And Installing Oil Pressure Switch For Reduced Oil Pressure F378 - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
4.5 Removing and installing oil pressure
switch for reduced oil pressure - F378-
Special tools and workshop equipment required
♦ 24 mm jointed spanner - T40175-
Removing
Vehicles with auxiliary radiator (left-side):
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
Continued for all vehicles
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Place a cloth underneath bracket for ancillaries to catch any
♦ respect to the correctness of information in this document. Copyright by SEAT S.A.
escaping oil.
Since the seal cannot be renewed individually, the oil pressure
♦
switch needs to be renewed following removal.
– Unplug electrical connector -arrow- at oil pressure switch for
reduced oil pressure - F378- .
– Unscrew oil pressure switch for reduced oil pressure -1-.
Fitting
Installation is carried out in the reverse order; note the following:
Note
Renew seal.
♦
Fit the new oil pressure switch for reduced oil pressure - F378-
♦
into the connection immediately to avoid loss of oil.
– Install the windscreen washer tank filler ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
– Check oil level
Specified torques
♦ ⇒ "4.2 Exploded view - oil pressure switches/oil pressure con‐
trol", page 222
⇒ page 203 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
4. Oil filter/oil pressure switches
225