Removing And Installing Hall Sender - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
1.4

Removing and installing Hall sender

⇒ "1.4.1 Removing and installing Hall sensor G40 ", page 455
⇒ "1.4.2 Removing and installing Hall sender 3 G300 ",
page 455
1.4.1 Removing and installing Hall sensor -
G40-
Removing
– Remove engine cover panel
– Now remove the intake manifold
⇒ "4.2 Removing and installing intake manifold", page 359
– Unplug electrical connector -3-.
– Unscrew bolt -1-, and remove Hall sender -2-.
Fitting
Installation is carried out in the reverse order; note the following:
– Renew O-ring.
Specified torques
♦ ⇒ "1.1 Assembly overview - ignition system", page 451
1.4.2 Removing and installing Hall sender 3 -
G300-
Removing
– Remove engine cover panel
– Unplug electrical connector -3-.
– Unscrew bolt -1-, and remove Hall sender -2-.
Fitting
Installation is carried out in the reverse order; note the following:
– Renew O-ring.
Specified torques
♦ ⇒ "1.1 Assembly overview - ignition system", page 451
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 57 .
⇒ page 57 .
EA 888 III. Gen) - Edition 10.2018
.
455
1. Ignition system