Align Exhaust System To Be Free Of Stress - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Cut through exhaust pipe -1- at right angles at separating point
-arrow- using chain pipe cutter - VAS 6254- or pneumatic sa‐
bre saw - V.A.G 1523B- .
Installing rear silencer
– Position clamp -1- centrally at side marks -arrows- when in‐
stalling.
– Turn clamp in such a way that there is sufficient clearance to
adjacent components.
– Align exhaust system free of stress
– Tighten threaded connections evenly.
Separating and joining centre silencer
– Cut through exhaust pipe of centre silencer at right angles at
separating point -arrow- using chain pipe cutter - VAS 6254-
or body saw - V.A.G 1523B- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Position clamp -arrow- centrally relative to side marks when
installing.
– Turn clamp in such a way that there is sufficient clearance to
adjacent components.
Specified torques
♦ ⇒ "1.1.4 Assembly overview - silencer, Cupra ST Carbon Fiber
Kit", page 395
1.6

Align exhaust system to be free of stress

Operation process
• The exhaust system must be aligned when it is cool.
• Specified torques
⇒ "1.1 Exploded view - silencers", page 391
⇒ page 411
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
.
1. Exhaust pipes/silencers
411