Seat Ateca 2017 Workshop Manual page 190

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Cut off nozzle of tube at front marking (nozzle dia. approx. 2
mm).
– Apply silicone sealant onto clean sealing surface of cylinder
head cover, as illustrated -arrows-.
♦ Thickness of sealant bead: 2 to 3 mm.
Note
The cylinder head cover must be installed within 5 minutes
♦
after applying the silicone sealant.
The line of sealant must not be thicker than prescribed, as
♦
otherwise excessive sealant will enter the sump and obstruct
the strainer in the oil intake pipe.
Observe use-by date of sealant.
♦
Sealant ⇒ Electronic Parts Catalogue (ETKA) .
– Fit exhaust camshaft in cylinder head cover as shown in illus‐
tration. Push cam pairs -A- and -B- towards each other.
– Place cylinder head cover on cylinder head with camshaft fit‐
ted.
– Renew bolts for cylinder head cover.
– Tighten bolts in several stages; tightening sequence
⇒ page 155 .
Note
Take care to keep cylinder head cover straight.
– Turn inlet camshaft in direction of arrow -1- until marking -3-
aligns with camshaft clamp - T40271/2- .
– Insert camshaft clamp - T40271/2- between splines of chain
sprocket in direction of -arrow 2-.
182
Rep. gr.15 - Cylinder head, valve gear
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.