Seat Ateca 2017 Workshop Manual page 71

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Removing
– Remove wheel housing liner (front right) ⇒ General body re‐
pairs, exterior; Rep. gr. 66 ; Wheel housing liners; Exploded
view - wheel housing liner (front) .
– Remove the poly V-belt
– Pull locking pin - T10060 A- out of tensioning device for poly
V-belt.
– Turn vibration damper to TDC position -arrow- using counter-
hold tool - T10355- .
• The notch on the vibration damper must oppose the arrow
marking on the lower cover of the timing chains.
• The marking on the cover is located at »4 o'clock position«.
– Unscrew the bolt for the vibration damper approx.
ing the counter-hold tool - T10355- .
– If vibration damper was turned while loosening bolt, reset TDC
position.
– Unscrew the 2 timing chain cover securing bolts -arrows-, as
shown in illustration. Bolts must be replaced.
– Fit support - T10531/1- to vibration damper, as shown in illus‐
tration, and tighten knurled screws -arrows- by hand.
– Unscrew vibration damper bolt completely.
⇒ page 60 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1
/ 2 turn us‐
1. Cylinder block (pulley end)
63