Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Installation
– Check installation position of tube for balance shaft; openings
-arrow- must face chain side.
– Lubricate bearing points of balance shaft -arrows- with engine
oil.
– Install balance shaft (exhaust side).
– Before tightening bolt -1-, check if balance shaft rests flat
against crankcase.
Note
If the balance shaft does not rest flat, the pipe for balance shaft
must be inserted again.
Further assembly is performed in the reverse order of removal.
During this procedure, observe the following:
– Install drive chain for balance shafts and camshaft timing chain
⇒ page 134
.
– Install timing chain cover (bottom)
– Install timing chain cover (top)
Specified torques
♦
⇒ "4.1 Assembly overview - balancer shaft", page 87
4.3
Renewing oil seal for balance shaft (inlet
side)
Special tools and workshop equipment required
92
Rep. gr.13 - Crankshaft group
⇒ page 123
.
⇒ page 121
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.