Removing And Installing Fuel Rail - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
11 - O-ring
❑ Renew after removing
2.2

Removing and installing fuel rail

Note
In this section, the work procedure for direct injection engines is
described.
Removing
Note
All cable ties must be installed in their same place again.
– Now remove the intake manifold
– Disconnect electrical connector -1- on fuel pressure sender -
G247- .
– Remove bolts -arrows-.
– Move clear wiring duct -2- at fuel rail, and pull fuel rail off in‐
jectors.
Note
If injectors remain inserted in the fuel rail, disconnect the relevant
connector.
Fitting
Installation is carried out in the reverse order; note the following:
– Fit extraction hose ⇒ page 359
Specified torques
♦ ⇒ "2.1.1 Assembly overview - fuel rail with injectors, direct in‐
jection", page 343
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 359 .
.
EA 888 III. Gen) - Edition 10.2018
345
2. Injectors