Seat Ateca 2017 Workshop Manual page 222

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Using assembly tool - T10118- , pull spring of chain tensioner
in direction of -arrow- and secure with locking tool - T40265- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove bolts -arrows- and detach oil pump.
Fitting
Install in the reverse order of removal, observing the following:
– Check that both centring sleeves are fitted in oil pump.
– Before installing oil pump, check strainer in oil intake pipe and
oil passages in sump (top section) for dirt.
– Guide oil pump sprocket into drive chain and install oil pump.
– Using assembly tool - T10118- , pull spring of chain tensioner
in direction of -arrow- and remove locking tool - T40265- .
– Slowly relieve tension from assembly tool - T10118- .
214
Rep. gr.17 - Lubrication