Seat Ateca 2017 Workshop Manual page 22

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Lay coolant hose -3- to one side.
– Unscrew bolts -1-.
– Release locking lugs-arrow-, unclip air hose -2- from the front
end and remove in -direction of the arrow-.
– Disconnect vacuum hose -2-.
– Press release tabs on vacuum hose -1-, and remove hose
from vacuum pump.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Vehicles with no auxiliary heater
– Lift the retaining clips -arrows- and detach the coolant hoses
from the heat exchanger for heater.
– Guide coolant hoses downwards and drain off coolant.
Vehicles with auxiliary heater
– Release hose clip -1-, lift retaining clips -arrows-, and discon‐
nect coolant hoses.
14
Rep. gr.10 - Removing and installing engine