Seat Ateca 2017 Workshop Manual page 314

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Remove front part of left wheel housing liner ⇒ General body
repairs, exterior; Rep. gr. 66 ; Wheel housing liners; Removing
and installing front wheel housing liners .
– If fitted, unclip air duct -1- -arrows-.
– Release catches -arrows A-, disconnect coolant hoses
-arrows B- and move clear at bracket.
– Set drip tray for workshop hoist - VAS 6208- underneath.
– Clamp off coolant hoses using the hose clamps - 3094- . Open
spring-type clips -1-, and remove hoses from auxiliary radiator.
– Remove nuts -arrows- and detach auxiliary radiator -1- with
bracket.
– Detach air duct -1- -arrow-.
– Remove bolts -4- and lift auxiliary radiator -2- off bracket -3-.
Fitting
Install in the reverse order of removal, observing the following:
– Install front part of left wheel housing liner ⇒ General body
repairs, exterior; Rep. gr. 66 ; Wheel housing liners; Assembly
overview - Front wheel housing liner .
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Install wheel ⇒ Running gear, axles, steering; Rep. gr. 44 ;
Wheels, tyres; Wheel change .
Specified torques
♦ ⇒ "4.2 Exploded view - auxiliary radiator", page 292
306
Rep. gr.19 - Cooling
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.