Removing And Installing The Oil Separator - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Tightening sequence - oil separator
– Tighten bolts to 9 Nm in sequence -1 ... 7-.
3.2 Removing and installing the oil separa‐
tor
Removing
– Release electrical connectors at ignition coils and unplug from
ignition coils simultaneously.
– Unscrew ignition coil bolts "3 and 4", and pull out ignition coils.
– Release hose clip -1- and detach hose from activated charcoal
filter solenoid valve 1 - N80- .
– Remove bolt -2- and detach crankcase breather hose -3- from
oil separator.
– Remove bolts -arrows- and detach oil separator.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew gasket and seals.
♦
Secure all hose connections with the correct type of hose clips
♦
(same as original equipment) ⇒ Electronic parts catalogue
(ETKA) .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Specified torques
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ ⇒ "3.1 Exploded view - crankcase breather system",
page 219
220
Rep. gr.17 - Lubrication