Seat Ateca 2017 Workshop Manual page 218

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Remove bolts -arrows-.
Top section of sump with 14 bolts
– Take out bolts -1 ... 14- and loosen the oil sump upper part
from the adhesive joint.
– Lever off upper part of sump on gearbox side first. Take care
timing chain cover is not bent when levering off.
Top section of sump with 18 bolts
– Take out bolts -1 ... 18- and loosen the oil sump upper part
from the adhesive joint.
– Lever off sump (top section) at gearbox end first. Take care
timing chain cover is not bent when levering off.
Fitting
♦ Silicone sealant: ⇒ Electronic Parts Catalogue (ETKA) .
Note
Observe use-by date of the silicone sealant.
♦
The sump (top section) must be installed within 5 minutes after
♦
applying the silicone sealant.
Replace bolts that are tightened with specified tightening an‐
♦
gle.
Renew seals, gaskets and self-locking nuts.
♦
– Eliminate the sealant residue from cylinder block, using a flat
rasp.
CAUTION
Risk of eye injury caused by sealant residue.
– Wear safety goggles.
210
Rep. gr.17 - Lubrication
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.