Seat Ateca 2017 Workshop Manual page 328

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1 - Air intake pipe
2 - Grommet
3 - Spacer bush
4 - Bolt
❑ 7 Nm
5 - Air intake hose
❑ Fitting ⇒ page 321
6 - air duct
7 - Intercooler system
❑ Removing and fitting
⇒ page 321
Note
If there are slight impressions on the
fins, refer to ⇒ page 10
8 - air duct
9 - Bonded rubber bush
❑ For charge air cooler
10 - Bonded rubber bush
❑ For charge air cooler
11 - Bolt
❑ 7 Nm
12 - Spacer bush
13 - Grommet
14 - Bolt
❑ 5 Nm
15 - Charger pressure sensor -
G31-
❑ Removing and fitting
16 - O-ring
❑ Renew after removing
17 - Air intake hose
❑ Fitting ⇒ page 321
18 - Air intake pipe
320
Rep. gr.21 - Turbocharging/supercharging
.
⇒ page 326
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.