Seat Ateca 2017 Workshop Manual page 458

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Vehicles with all-wheel drive
– Unscrew temperature sender behind particulate filter - G527-
-1-.
Note
Disregard -item 2-.
Vehicles with front-wheel drive
– Unscrew temperature sender behind particulate filter - G527-
-1-.
Installation
Install in reverse order of removal, observing the following:
• Take care to protect exhaust gas temperature sender from
knocks and impact: do not use exhaust gas temperature sen‐
sors which have fallen to the ground.
Vehicles with all-wheel drive
– Move temperature sender behind particulate filter - G527- to
installation position:
• Angle -α- = max. 15°.
Vehicles with front-wheel drive
– Move temperature sender behind particulate filter - G527- to
installation position:
• Angle -α- = max. 15°.
Specified torques
♦ ⇒ "3.1 Assembly overview - exhaust gas temperature regula‐
tion", page 445
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody
cladding; Assembly overview - underbody cladding
450
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.